Solutions Of Common Problem For POS Printer(2)
news
Contact Us
Telephone Number: +86-10-82781467
Fax Number: +86-10-62988681
Email: info@sprt-printer.com
Website: www.sprt-printer.com
news

Solutions Of Common Problem For POS Printer(2)

2017-11-08 11:12:06

1. Printer can’t print complete data and printing deviation.
Please add feed command(0A 0D). When printer print deviate left, please adjust driver printing pitch.
2. Wi-Fi Setting Tool
Set to AP Mode
“No setting” can be choosed for the options which don’t need to be set.
The steps are as below,
1.Choose the current port. Then choose <AP> for wifi mode and click the button of “Set Wi-Fi Mode”
2.TCP connection. “Protocol Type” to be <TCP SERVER> (MUST choose “TCP SERVER”); Set “Port”: such as <9100>
3.Set “Name” under AP mode: such as <SPRT>
4.Encryption type: When choosing<OPEN> for encryption type, no password is need; when choosing <WPA2PSK>, password is need. The length of password needs to be over or equal to 8bits.
5.Network parameters: choose <Set> : “IP address” to be <192.168.1.1>; “Subnet Mask” to be <255.255.255.0>
6.Click “Set” button

Now AP mode setting is finished. Now start to print. Firstly, the terminal needs to be connected with AP. The connection steps are as below,
1.Turn on the printer
2.The host device search for WIFI
3.If there are several “WIFI”, choose SPRT printer. 
4.Input password “12345678”
5.Finish connection.

Set to STA Mode
No setting” can be choosed for the options which don’t need to be set.
The steps are as below,
1.Choose the current port. Then choose <STA> for wifi mode and click the button of “Set Wi-Fi Mode”
2.TCP connection. “Protocol Type” to be <TCP SERVER> (MUST choose “TCP SERVER”); Set “Port”: such as <9100>
3.Click button “Scanf AP (need 10s)”. About ten seconds later, there will be much information showed in the left list. Choose the router you need to connect and input password.

Solutions Of Common Problem For POS Printer(2)

4.Set “Name” under STA mode: such as <SPRT>
5.Set “IP Mode”: pls choose <static>. Set “IP address” “Subnet Mask” “Gateway” according to the parameters of Router. For example, “IP address” to be <192.168.1.100>,  “Subnet Mask” to be <255.255.255.0>, “Gateway” to be <192.168.1.254>
6.Click “Set” button

Now STA mode setting is finished. Now start to print. Firstly, the terminal and printer need to be connected with one router. The connection steps are as below,
1.After turn on, the printer will connect with the set router automatically
2.The host device searches the router
3.Connect with the router which connects with the printer
4.Input router password
5.Finish connection.